Summary of EMC Directive Satisfaction - DEN-S-NET-xx
Revision History
Rev. | Date | Change Description | Author | Approved by |
|---|---|---|---|---|
A |
| Document Creation | L. van Noort |
|
Scope
Manufacturer | Novanta Technologies Spain S.L. C\ Àvila 124 2B, 08018, Barcelona, Spain |
|---|---|
Authorized Representative*: *An Authorized Representative is required for CE marking directives/regulations when the Manufacturer is located outside of the EU, or for UKCA marking when the manufacturer is located outside of the UK. | N/A |
Product Description: | Denali Safe NET |
Part Number: | DEN-S-NET-xx |
Scope*: *i.e. the Regulation, Directive or Voluntary Certificate that is satisfied | EMC Directive 2014/30/EU |
Introduction
This document sets out to summarize the actions undertaken by the manufacturer to satisfy the Directive, Regulation or other (legal) requirement as described in the document Scope.
Applied Harmonized Standard(s)
The following standards were applied, published in the Official Journal of the EU (OJEU):
Standard Reference | Title |
|---|---|
EN 61800-3:2004/A1:2012 or more recent | Adjustable speed electrical power drive systems - Part 3: EMC requirements and specific test methods for PDS and machine tools |
Essential (Safety) Requirements
The EMC Directive 2014/30/EU [1] sets out a list of Essential Requirements in Annex I, the checklist below identifies the requirements that apply, and how they are satisfied.
EMC Directive Essential Requirements [1]
# | Requirement | Applicable (Y/N) | (If applicable) Satisfied through (If not applicable) Justification |
|---|---|---|---|
1(a) | Equipment shall be so designed and manufactured, as to ensure that the electromagnetic disturbance generated does not exceed the level above which radio and telecommunications equipment or other equipment cannot operate as intended; | Y | Certified to Harmonized Standard Standard EN 61800-3:2004/A1:2012 and EN IEC 61800-3:2018. Test results can be found here: [3] |
1(b) | Equipment shall be so designed and manufactured, as to ensure that it has a level of immunity to the electromagnetic disturbances to be expected in its intended use which allows it to operate without unacceptable degradation of its intended use. | Y | |
2 | A fixed installation shall be installed applying good engineering practices and respecting the information on the intended use of its components, with a view to meeting essential requirements set out in point 1. | N | Product is not a fixed installation per definition given in the text of the EMC Directive [1] |
Conclusion
As all Essential Requirements are accounted for, the product referenced in the document Scope is declared in conformity with the EMC Directive 2014/30/EU.
References
# | Description | Link |
|---|---|---|
[1] | EMC Directive 2014/30/EU | |
[2] | EC-Type Certification | Robotics & Automation Group - 01_205_6022_00_25_en_el.pdf - All Documents |
[3] | EMC Test Results | Robotics & Automation Group - Documents - EMC test reports - All Documents |