Skip to main content
Skip table of contents

Firmware 1.0.0

Initial release

Known issues

IDdescriptionworkaround

SUMMIT-1585

Max. current should not accept negative values

Only write positive values to Max. Current

SUMMIT-1566

First forced alignment with halls after having done another forced alignment with another feedback, fails

If forced alignment result is not a multiple of 0.166666 (including 0.0 and 1.0), change commutation feedback to internal generator, then change commutation feedback back to digital halls and perform phasing again.
SUMMIT-1568

Profiler acceleration / deceleration must not have negative values with current implementation

Only write positive values to profiler acceleration and profiler deceleration.
SUMMIT-1471External fault is triggered constantly

Mask error using external fault error option code

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.