Skip to main content
Skip table of contents

Firmware 1.3.3

New Feature

Bug

  • [SUMMIT-1763] - Drive gets stuck if monitoring sampling is set above 10 kHz
  • [SUMMIT-1769] - Monitoring number of blocks register is limited to uint16 range and in OP state.
  • [SUMMIT-1683] - Position range limits wrapping is not executed correctly in the whole range
  • [SUMMIT-1758] - PVT mode is not reaching the end points (final position and velocity) correctly
  • [SUMMIT-1785] - Setting a wrong operation mode and enabling the motor freezes the drive
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close