Skip to main content
Skip table of contents

Firmware 1.3.2


  • [SUMMIT-1698] - During forced alignment, hall combination error happens
  • [SUMMIT-1732] - Remove unused modules to reduce power consumption
  • [SUMMIT-1738] - Biss-C doesn't read anything on boot-up
  • [SUMMIT-1744] - Sometimes Store all is not working properly
  • [SUMMIT-1747] - Biss-C can have an undesired soft multiturn when changing frame size, baudrate, etc
  • [SUMMIT-1723] - Canopen is getting stuck when TPDO are configured with Sync at 1ms
  • [SUMMIT-1737] - CANopen: target position is not processed by SDO when it is mapped to PDO and in OP state.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.