Skip to main content
Skip table of contents

Firmware 2.3.0

Bug

  • [EVR-930] Trapezoidal commutation is being inefficient
  • [EVR-926] Voltage quadrature command stays around the initial value in CANopen
  • [EVR-891] Torque offset register 0x60B2 not being properly calculated in EtherCAT
  • [EVR-879] Wrong EtherCAT EMCY message when clearing a fault
  • [EVR-788] Max current register 0x6073 not being properly calculated in EtherCAT

Improvement

  • [EVR-897] Refactor of absolute feedback names
  • [EVR-785] Object 0x1003 pre-defined error field wrong abort code when no error

New Feature

  • [EVR-858] Implement 0x603F error code register over CANopen
  • [EVR-769] Implement 0x6062 position demand register

Known issues

IDDescriptionWorkaraund
EVR-898

Manufacturer specific Store/restore all return wrong error codes (CANopen)

None
EVR-898Default values read from the drive are not the same as those in the EDS file (CANopen)None

Register comms cycle timeout 0x5EC5 is not being stored in CAN FW

None

Registers monitoring-disturbance channel map cannot be written

None
[MOT3-2748]Register 0x1003 subindex 1 returns an error code when connecting to the device using MotionLab 1.5.0 through CAN. It does not affect the drive functionality and will be fixed in future MotionLab release.None
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.