Installation Manual

Unboxing

When unboxing the drive please ensure the following:

Remove it from the bag carefully.
Check that there is no visible physical damage. If any, report it immediately to the carrier.
Check the part number of the drive on the side label.

Installation Safety Requirements

The drive has live circuits that can be touched and could entail a risk of electric shock, as well as a risk of thermal injury. It must be mounted on a closed electrical operating area to which access is restricted to skilled or instructed personnel. To ensure electrical safety it is also important that the environment is clean from conductive pollution or condensation when the drive is powered (Pollution degree 2).

	WARNING HOT SURFACES!
	The drive and motor can become hot and cause severe burns. If any of the user-accessible surfaces exceeds 70 ºC, a hot-surface signal must be added. This is the responsibility of the installer.
	DANGER, ELECTRIC SHOCK!
	Power and motor pins have live voltages which can exceed 50 V which can cause electric shock! Perform installation procedures without voltage. Ensure the drive is mounted on a closed electrical operating area which protects against direct contact.
Important: The drive does not come with a pre-installed fuse. For protection, a branch fuse is necessary. The following fuse has been tested and approved: Littelfuse JLLN045.TXP.
Warning: The drive is not designed for direct connection to the mains supply. It must be used with a SELV power supply that ensures galvanic isolation.

The drive may be operated without enclosure and protection against electric shock when it is supplied at Extra Low Voltage (ELV), ≤ 50 V.

Mounting the Drive to an Interface Board

The drive has 4x M2.5 holes for assembling the drive to an interface board. See Dimensions section for further details. The following must be taken into consideration when installing the drive:

The drive must be screwed to the board using 4xM2.5 screws. The length of the screw on the drive side should be at least 6mm.
- Total length of the screw = 6mm + height of the interface board
The maximum recommended torque to be used is 0.31Nm.
3 mm spacers must be used to ensure the board-to-board distance between the interface board and the drive.
The total length of the screws will depend on the height of the interface board:
- Total length of the screw = 6mm + height of the interface board + height of spacers