Skip to main content
Skip table of contents

Firmware 1.1.1

Bug

  • [SUMMIT-1640] - Derating is applied to user nominal current instead drive maximum current

Known issues

IDDescriptionWorkaround

SUMMIT-1566

First forced alignment with halls after having done another forced alignment with another feedback, fails

If forced alignment result is not a multiple of 0.166666 (including 0.0 and 1.0), change commutation feedback to internal generator, then change commutation feedback back to digital halls and perform phasing again.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.